Hot-Dip Galvanised Steel Balcony Stand – 1 m Two-Piece Mast Ø 48 mm, for 500 × 500 mm Concrete Slabs
The AS32054 is a ballasted steel balcony and terrace stand designed for suitable satellite and antenna installations where conventional wall or roof mounting is not desired.
According to the available product data, the structure is manufactured from hot-dip galvanised steel according to EN ISO 1461.
The welded base frame is designed for 500 × 500 mm concrete slabs, which are not included.
The mast has an outside diameter of Ø 48 mm and a total height of 1000 mm. It is manufactured as a two-piece mast for easier transportation and storage.
Anti-slip rubber feet are installed under the base frame according to the available product information.
For 500 × 500 mm concrete slabs
The stand is designed for slabs measuring:
500 × 500 mm
50 × 50 cm
Concrete slabs are not included.
Ballast must suit the installation
The required ballast cannot be determined from slab dimensions alone.
Relevant factors include:
actual slab weight
antenna size
antenna wind area
mast height
installation height
building exposure
local wind conditions
Depending on the application, multiple concrete slabs may be required.
No universal slab quantity specified
The available product data does not define one fixed number of slabs as suitable for every installation.
The actual ballast mass must be assessed for the specific antenna and location.
Ø 48 mm mast
Mast specifications:
Outside diameter: Ø 48 mm
Total height: 1000 mm
The antenna clamp must be compatible with a Ø 48 mm mast.
Two-piece mast
The mast can be separated into two parts.
This simplifies:
transport
storage
relocation
seasonal use
Welded steel base frame
The base frame is supplied as a welded steel construction according to the product information.
Assembly with three screws
According to the available product information, the system can be assembled using three screw connections.
All connections should be checked for secure seating before use.
Anti-slip rubber feet
Rubber feet under the base support stable contact with suitable surfaces and can reduce direct steel-to-surface contact.
They do not replace adequate ballast.
Hot-dip galvanised steel
The steel construction is hot-dip galvanised according to EN ISO 1461.
This supports corrosion protection for outdoor use.
Typical applications
The AS32054 can be used for suitable:
satellite installations
balcony installations
terrace installations
temporary antenna systems
suitable flat-roof installations
DVB-T/T2 antennas
DAB/DAB+ antennas
FM antennas
Maximum antenna size not specified
No specific maximum satellite dish diameter is stated in the available product data.
Suitability depends on the complete installation, ballast and local wind conditions.
Balcony and roof load capacity must be checked
Concrete ballast can add considerable weight.
The supporting surface must be suitable for the complete load of the installation.
Flat-roof installations
When used on a suitable flat roof, special attention must be paid to:
roof load capacity
waterproofing
point loads
wind uplift
roof edge zones
protection of the roof membrane
Technical specifications
Article reference: AS32054
Article number: 32054
EAN: 4050822320547
Product type: Steel balcony / terrace antenna stand
Material: Steel
Surface: Hot-dip galvanised according to EN ISO 1461
Base frame: Welded
Concrete slab size: 500 × 500 mm
Concrete slabs included: No
Mast diameter: Ø 48 mm
Mast height: 1000 mm
Mast design: Two-piece
Feet: Anti-slip rubber feet
Assembly: 3 screws according to product information
Maximum antenna size: Not specified
Package contents
1 × AS32054 steel balcony stand
1 × two-piece Ø 48 mm mast, 1000 mm total height
Base frame and rubber feet according to product configuration
Assembly screws according to product configuration
Concrete slabs, satellite dish, LNB, coaxial cable and additional installation equipment are not included.