Hot-Dip Galvanised Pipe Clamp for Outriggers up to Ø 60 mm – with Two Serrated Clamps
The AS46303 is a robust steel mounting clamp designed to secure suitable round-tube outriggers up to Ø 60 mm.
It is intended for satellite, antenna and technical mast installations where an outrigger or round support tube must be fixed to a suitable load-bearing mounting structure.
According to the available product data, the AS46303 uses two serrated clamps to grip the tube at two separate positions.
The steel construction is hot-dip galvanised and measures approximately 10.5 × 10.5 × 13.5 cm.
For outriggers up to Ø 60 mm
The clamp is suitable for round-tube outriggers with an outside diameter of:
up to Ø 60 mm
The actual tube diameter should be checked before installation.
Two serrated clamps
The AS46303 uses:
2 serrated clamps
The two clamping points support tube guidance and help resist unwanted movement or rotation.
Helps resist rotation
The serrated surfaces increase grip on the tube.
Actual holding performance depends on:
tube diameter
surface condition
wall thickness
tightening force
outrigger length
antenna weight
wind load
The assembly should therefore not be regarded as absolutely rotation-proof under all conditions.
Hot-dip galvanised steel
The mounting structure is manufactured from hot-dip galvanised steel.
This surface treatment supports corrosion protection for typical permanent outdoor installations.
Compact dimensions
Approximate overall dimensions:
10.5 × 10.5 × 13.5 cm
Distance from base plate to first clamp
The distance from the base plate to the first serrated clamp is approximately:
6 cm
according to the available product data.
Satellite wall-mount applications
The AS46303 can be used as part of a suitable satellite wall-mount system with a compatible round-tube outrigger.
The final wall offset depends on the length and geometry of the attached outrigger.
Lever forces must be considered
Long outriggers create additional leverage at the mounting point.
The complete installation must therefore take into account:
outrigger length
antenna weight
wind area
mounting height
wall construction
fixing hardware
No maximum antenna size specified
No confirmed maximum satellite dish or antenna size is stated for the AS46303.
The suitability of the complete system depends on all structural components.
Other antenna applications
Depending on the complete mechanical design, the clamp may also be used for suitable:
DVB-T/T2 antennas
DAB/DAB+ antennas
FM antennas
radio antennas
directional antennas