Goliat Flat-Roof and Terrace Satellite Stand – Ø 48 mm Mast, 900 mm Height, Adjustable up to 2°
The AS32440 is a ballasted steel antenna stand designed for suitable satellite and antenna installations on flat roofs, terraces and other structurally suitable level surfaces.
According to the available product data, the structure is manufactured from hot-dip galvanised steel according to EN ISO 1461.
The integrated mast measures Ø 48 mm and is 900 mm high.
The mast position can be adjusted by up to approximately 2°, allowing minor surface deviations to be compensated and helping achieve a more vertical mast position.
The base is designed for 400 × 400 mm concrete slabs. According to the product information, at least four concrete slabs are used.
Concrete slabs are not included.
For 400 × 400 mm concrete slabs
The base is designed for slabs measuring:
400 × 400 mm
40 × 40 cm
At least four slabs according to product data
The available product data specifies at least four concrete slabs.
This should not be interpreted as universal wind-load approval for every antenna and every location.
The actual ballast requirement depends on:
slab weight
antenna weight
antenna wind area
installation height
building height
local wind conditions
Ø 48 mm mast
Mast specifications:
Outside diameter: Ø 48 mm
Height: 900 mm
The antenna clamp must be compatible with a Ø 48 mm mast.
Adjustable mast position up to approx. 2°
The mast can be tilted or adjusted by up to approximately 2°.
This adjustment is intended for minor alignment corrections rather than large-angle positioning.
Useful for accurate antenna alignment
A mast positioned as vertically as possible simplifies subsequent satellite dish alignment.
Suitable for satellite data applications
The stand can also be useful for suitable bidirectional satellite communication or data systems where stable antenna positioning is important.
Actual suitability depends on the specific antenna weight, wind area and mounting arrangement.
Anti-slip rubber feet
According to the product data, the stand includes anti-slip rubber feet.
These support stable contact with suitable surfaces but do not replace adequate ballast.
Hot-dip galvanised steel
The structure is hot-dip galvanised according to EN ISO 1461, supporting corrosion protection for outdoor use.
Assembly with six screws
According to the available product information, the stand is assembled using six screws.
No maximum satellite dish size specified
No confirmed maximum satellite dish diameter is stated in the available data.
Suitability must therefore be assessed from the complete installation.
Flat-roof installations
When installed on a flat roof, particular attention must be paid to:
roof load capacity
waterproofing
point loads
wind uplift
roof edge zones
Technical specifications
Article reference: AS32440
Article number: 32440
EAN: 4050822324408
Product type: Flat-roof / terrace antenna stand
Material: Steel
Surface: Hot-dip galvanised according to EN ISO 1461
Mast diameter: Ø 48 mm
Mast height: 900 mm
Mast adjustment: Up to approx. 2°
Concrete slab size: 400 × 400 mm
Ballast according to product data: At least 4 concrete slabs
Concrete slabs included: No
Feet: Anti-slip rubber feet
Assembly: 6 screws according to product information
Maximum antenna size: Not specified
Package contents
1 × AS32440 flat-roof / terrace antenna stand
1 × Ø 48 mm mast, 900 mm high
Base frame and anti-slip rubber feet according to product configuration
Assembly screws according to product configuration
Concrete slabs, satellite dish, LNB, communication equipment, coaxial/data cables and additional accessories are not included.